10-14-2022, 03:58 PM | #1 |
New Member
13
Rep 28
Posts |
Motiv CAN patch is making my whole car erratic
I am setting up my Reflex+ on a 2018 M3, S55. All is working well, except when I upload the bin with the MHD patch applied, the car starts acting erratic. With ignition on, the fuel pump will go on and off. I get new error codes like ABS and airbag. When I start the car, the tach will jump from OFF to ~800rpm and bounce back and forth.
Tuner pro shows datalogging but MHD cannot read the ethanol CAN %. Just shows 0% but tuner pro shows 9%. When I flash back to the stock s55 bin provided from motiv’s website, the car is back to normal. I have MHD flashed with stage 0 and Motiv ECA set. Here is the output from MHD: View post on imgur.com |
10-15-2022, 04:55 PM | #2 |
Captain
773
Rep 957
Posts |
Make sure your Motiv connector wires are hooked up to the correct DME pins. Double check install. My best advice is, reach out to your tuner or installer.
__________________
M4CS Frozen Blue
ARM DP's/Resonated Mid-pipe | SPL links | Hotchkis bars | JRZ RS2/camber plates | K&N | Koyorad HX | Powerflex purple | Rouge | Spiegler | Speed Eng. snorkel | Vargas CBC/hub | Wagner IC | xHP | Xpel stealth ppf |
Appreciate
1
spidy512502.00 |
10-16-2022, 10:55 AM | #3 | |
New Member
13
Rep 28
Posts |
Quote:
I did the install. Wires appear to be okay, according to the wiring table motiv provides. Don’t have anyone tuning the car yet as I’m still getting things working. I reached out to motiv but no answer yet, so trying to poke some brains in the community. |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|