|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
BMW 3-Series (E90 E92) Forum
>
E90 330D - Crankshaft Pulley (deteriorating?) and Belt Tension Loose? [VIDEO]
|
|
04-28-2019, 02:54 PM | #1 |
Captain
132
Rep 826
Posts |
E90 330D - Crankshaft Pulley (deteriorating?) and Belt Tension Loose? [VIDEO]
Hi All,
Getting ready to take it to Chemix tomorrow to hopefully see if the new hub and arms have solved the bend preventing a proper adjustment but after doing some checks I noticed that it looked like the belt was wobbling slightly, so I stopped the engine and noticed the belt seems very slack and I also check the crankshaft pulley as theres a squeek that I always get when I shut the engine off (this was before when tension on the belt was solid) and I cant quite make out whether the crankshaft pulley is wearing on the outside or not? And then the tensioner looks like it's on a bouncy castle.. looking at the first video you can see I can pull the belt with one hand and move the tensioner belt which I'm sure you shouldn't be able to do Last edited by MrSweet1991; 04-28-2019 at 03:15 PM.. |
04-28-2019, 06:50 PM | #2 |
Private
4
Rep 83
Posts |
I am sure I can clearly see cracks in the rubber of the vibration damper and your tensioner is on its wayout as the belt is starting to ride of it.
New vibration damper and tensioner required. Turning out to be quite expensive for you. |
Appreciate
0
|
04-28-2019, 08:14 PM | #3 | |
Captain
132
Rep 826
Posts |
Quote:
also, does this mean 60nm plus one turn of 60 degrees then another 60 degrees? (M57TU) https://www.newtis.info/tisv2/a/en/e...damper/5zHAukc |
|
Appreciate
0
|
04-29-2019, 04:45 AM | #4 | |
Private
4
Rep 83
Posts |
Quote:
|
|
Appreciate
0
|
05-13-2019, 09:33 PM | #6 |
New Member
1
Rep 17
Posts |
I think I have a similar issue, do you hear a skrr skrr skrr sound on startup? It goes after a good 30mins of the car being started it being driven a bit.
It comes from near the belt so I'm assuming its a similar issue? |
Appreciate
0
|
05-14-2019, 03:45 AM | #7 |
Captain
132
Rep 826
Posts |
To be honest, I have the crankshaft pulley a clean and a wipe over and when I took another picture it actually looked in good condition and it turns out the crankshaft pulley was a good brand as well and was replaced in 2017 so I'm not sure what to think now, ideally I could do with removing the belts but the power steering belt needs a tool to remove and put back on so I can't give it a proper check. For me I'm just going to replace the belt tensioner and see how I get on. And no, i dont hear any sound on startup to be honest, have you got a video of yours?
|
Appreciate
0
|
Bookmarks |
|
|