JB4 - 2step/NLS install problem??
So i jst got done installing my jb4 along with the 2step/NLS relay. I start the car, everythins working fine. I set up NLS in menu 8. I set it to a low setting just to get a feel for it. 2500rpm
Now it works fine. But i noticed that i can make it activate by just pressing the pedal down to the floor. I thought you had to press the clutch all the way AND press the throttle pedal 100% to the floor.
Why am i able to enable 2step/nls by just pressing the throttle to the floor. I followed BMS install pdf for both the jb4 and the nls relay.
Everythings setup properly i think as far as the menus. I enabled map 5. Startup gauge sweep. Boost gauge on fuel. So its all working correctly. I jst dont want to put everything back and find out theres a problem.
So is that normal?
|