When I try to do Identification in ISTA/D (using OBD cable through ICOM emu; in connection manager I'm able to select ICOM device) the program says that my voltage is only 12 V and it's recommended to use higher, I press ok and after a while it sends an error reading VIN. Then I put VIN manually, however ECU tree is no being read properly and I don't have any modules shown in green.
It seems like system sees ICOM emulator, but there is no data transfer through OBD cable going on. Cable tested in INPA/WinKFP/NCSExpert - works fine. In VM it has COM9 assigned.
Can anyone suggest how to make things working?
|